Hey Guys,
Russell had sent me the shock spacers that he had previously purchased from D3 for using when mounting lowering springs. The spacers are already polyeurethane. Russell also mentioned that someone was making them for the CTS-V and that they may be close enough to fit. Any ideas. I'd rather not buy from D3 at this point. I'm thinking of taking pic and detailed measurements and sending them to Johnny to get his opinion.

Thoughts?

P.J.

PJ
I sent Russell the measurement of the ones I got from Ebay. They were made by a CTS-V guy. I have not used them yet but they should fit just fine.

PJ
I got information from jamie:
I have 2 rubber washers by Hillman that are 3/8 x 2-1/4 x 1/8 and the barcode is 0823676950 and part# H 882643 and 2 larger Poly bushings that are 1.72" or 43.72mm wide by 1" or 25.44mm and has a .67" or 17.13 hole drilled direct in the middle of the bushing. The guy I bought them from is

Ryan Skarzenski
10309 Rosser Rd
Dallas, TX 75229

Hope this helps

Gentleman,
I haven't acted on the CTSV bushing as yet. I was hoping for a screen name
to contact them through that forum first maybe a PM or something.
If any one knows this guys screen name please send it to me.
The search engine on the other forum is for not.
Rissell

Odysseus and WildWhl